Checking The Status Of The Flexible High-Speed I/O Control Module With System Monitor - Mitsubishi Electric MELSEC-L Series LD40PD01 User Manual

14.7
Checking the Status of the Flexible High-speed I/O
Control Module with System Monitor
Select "H/W Information" of the flexible high-speed I/O control module in the system monitor of GX Works2 and check the
LED status and the setting status of the switch setting.
H/W LED Information
The LED on/off status is displayed.
No. LED name
(1) RUN LED
(2) ERR. LED
H/W SW Information
The setting status of the switch setting is displayed.
• When "Invalid" is set for "Hardware logic control valid/invalid during disconnecting", 0000 is displayed in "HWL CTRL".
• When "Valid" is set for "Hardware logic control valid/invalid during disconnecting", 0001 is displayed in "HWL CTRL".
(1)
(2)
On/off status
0000H: The LED is off.
0001H: The LED is on.
Alternately displayed 0000H and 0001H: The LED flashes. (As the state in communication is displayed,
0000H and 0001H are not always displayed for the same period of time.)

14.7 Checking the Status of the Flexible High-speed I/O Control Module with System Monitor

14 TROUBLESHOOTING
239
14