Program example
The following provides program examples. Write the programs to the CPU module on the master station.
■Common program
A program example to check the data link status of the head module (station number 1)
(1) Check the data link status of the head module (station number 1).
Add the MCR instruction shown below to the last of the program.
■Program example 1
A program example to turn on Hardware logic control stop signal at disconnection (Y1006)
(1) Turn on Hardware logic control stop signal at disconnection (Y1006).
■Program example 2
A program example to configure the clear setting of error history
(1) Store Clear the history. (1) in Clear setting of error history (Un\G8002).
13 PROGRAMMING
226
13.3 When the Module Is Connected to a Head Module
(1)
(1)
(1)