Pulse Measurement - Mitsubishi Electric MELSEC-L Series LD40PD01 User Manual

10.9

Pulse Measurement

The ON width or OFF width of an input signal is measured.
10
ON
Input signal
OFF
ON width OFF width
The following describes a link and parameter example of a pulse measurement. With the example setting, the ON width (latch
value × 25ns) of the input signal is measured. Note that this link example is for when a 32-bit unsigned multi function counter
block is used.
Link and parameter
The following shows a link example of the hardware logic outline window and a link example and parameter setting example
of the multi function counter block detail window.
■Hardware logic outline window
10 BLOCK LINK EXAMPLES
201
10.9 Pulse Measurement