Performance Specifications - Mitsubishi Electric MELSEC-L Series LD40PD01 User Manual

3.2

Performance Specifications

The following table lists the performance specifications of the flexible high-speed I/O control module.
Item
Number of input points
Number of output points
Number of interrupts
Input response time
Output response time
Pulse input speed
Pulse output speed
*1
Main block External input
block
Y device terminal
OUT terminal
Parallel
encoder block
SSI encoder
block
Multi function
counter block
Logical
operation block
External output
block
SI device terminal
3 SPECIFICATIONS
24
3.2 Performance Specifications
Logic Select
Filter Time
Initial State
Input Data Type
Data Length
Input Data Type
Data Length
Terminal
Input signal event detection block
Latch event detection block
Counter timer Type
block
Internal clock
Counting range
Compare block Compare Value
Compare Mode
Cam switch Refreshing
block cycle
Number of
steps
Set/reset block
Logical operation type
Logic Select
Delay Time
Error-time Output Mode
Specifications
Differential
12 points (common for 5VDC/24VDC/differential)
6 points
8 points
1μs or less
1μs or less
Max. 8Mpps (2MHz)
Max. 8Mpps (2MHz)
Inverted, not inverted
General-purpose 0μs, 10μs, 50μs, 0.1ms, 0.2ms, 0.4ms, 0.6ms, 1ms, 5ms
input:
Pulse input: 10kpps, 100kpps, 200kpps, 500kpps, 1000kpps, 2000kpps,
4000kpps, 8000kpps
Low, High
Outputs the ON/OFF states of General command 0 to General command F (Y10 to
Y1F) as signals.
Outputs the same signal as the one to be output from the external output block.
Pure binary, Gray code, BCD
1 bit to 12 bits
Pure binary, Gray code
1 bit to 32 bits
Input terminal, latch input terminal, event input terminal, output terminal, event output
terminal, cam switch output terminal
Combination of rise, fall, Low, and High
Rise, fall
Addition, subtraction, linear counter mode, ring counter mode, addition mode, preset
counter function, latch counter function, internal clock function
25ns, 50ns, 0.1μs, 1μs, 10μs, 100μs, 1ms
32-bit signed binary (-2147483648 to 2147483647)
32-bit unsigned binary (0 to 4294967295)
16-bit signed binary (-32768 to 32767)
16-bit unsigned binary (0 to 65535)
Same as the counting range
16-bit counter: =, >, <, ≥, ≤, <>
32-bit counter: =, >, <, ≥, ≤, <>
0.1μs
Up to 16 steps
Uses the signal input to the Set terminal as a trigger to output the High fixed signal.
Uses the signal input to the Reset terminal as a trigger to output the Low fixed signal.
AND, OR, XOR
Inverted, not inverted
None, 12.5ns × (1 to 64), 25ns × (1 to 64), 50ns × (1 to 64), 0.1μs × (1 to 64), 1μs × (1
to 64), 10μs × (1 to 64), 100μs × (1 to 64), 1ms × (1 to 64)
OFF, ON, HOLD
Interrupt to a CPU module
DC
8 points (5 to 24VDC, 0.1A/point)
Max. 200kpps (200kHz)
Max. 200kpps (200kHz)