Mitsubishi Electric MELSEC-L Series LD40PD01 User Manual page 190

■Multi function counter block detail window
Block
Input 0
Input 1
Input_Signal_Event
Counter_Timer_0
Cam Switch
Cam Output
*1 Cycle time = (Upper limit value - Lower limit value) × Clock cycle
*2 ON time = Cycle time - (Step No. 0 × Clock cycle)
*3 In the addition mode, the cycle time calculated from the following is applied.
Cycle time = (Upper limit value - Lower limit value) ÷ Addition value × Clock cycle
The items other than the above need not to be set.
10 BLOCK LINK EXAMPLES
188
10.5 PWM Output
Variable name Setting value
 
 
Detector Select User Setting (ON only in A: Rise)
Detector Select User Setting (ON only in B: Rise)
Count Enable ON
Count Mode Ring
Upper Limit 10
Lower Limit 0
Clock 1ms
Add Mode OFF
Add Value 0
STOP → PRESET
ON
Preset Value 0
Number of Step 1
Lower Limit Output State Low
Step No.0 3
 
Description


Set conditions to detect a PWM output start signal.
Set conditions to detect a PWM output stop signal.
Set this parameter to "ON".
Set this parameter to "Ring".
Set this parameter according to the control.
Set this parameter according to the control.
Set this parameter according to the control.
Set this parameter according to the control.
Set this parameter to "ON", to perform a preset when
a stop event occurs.
Set the same value as that in "Lower Limit".
Set "1" to enable the step No. 0.
Set this parameter to "Low".
Set this parameter according to the control.

*1
*1
*1*2
*3
*2