Dynamic Sw Limit Switches For Following Axes; Corresponding Data; Description Of Function - Siemens SINUMERIK 840C Installation Instructions Manual

12 Functional Descriptions

12.31 Dynamic SW limit switches for following axes

12.31
12.31.1
• MD 560*, bit 1
• MD 560*, bit 5
• MD 3932*
• MD 3936*
• DB32 DR[K], bit 3
• DB32 DR[K+1], bit 2
• DB10 ... 15, DR0. bit 0
General
• Behaviour of following axis without monitoring
If a gear interpolation is active in the SINUMERIK 840C, then the software limit switch for
the following axis is monitored only when the actual position is exceeded. If the following
axis crosses the limit switch, a servo alarm (148* to 152*) is output and the axis grouping
braked. In this case, the axis travels a long distance passed the limit switch depending on
its speed.
• Behaviour of following axis with monitoring
The purpose of the function is to monitor the position of the following axis continuously
and, if required, to reduce the path speed of the channels in the mode group such that the
following axis travels only a short distance past the switch. The axis grouping is not
separated.
12.31.2
• Sequence
The SW limit switches for following axes are monitored only if
– MD 560*, bit 1 = 1 "Dyn. SW limit switches for following axes"
– MD 560*, bit 5 = 1 "Software limit switches active"
– Axis is referenced
– Axis is following axis when gear interpolation is active
– C axis in C axis mode, not spindle mode
– PLC signal to axis, bit 2 = 0: "Dynamic SW limit switch monitoring passive"
– PLC signal to channel, bit 0 = 0: "Path speed of channel not reduced"
The axis-specific PLC signal "Dynamic SW limit switch monitoring passive" allows the user
to switch the monitoring function on and off. The signal to channel "Path speed of channel
not reduced" determines whether the path speed of the channel is reduced.
• Reduction range
A braking path is calculated for each following axis from the max. velocity V
max. acceleration A
of the software limit switches that is referred to as "reduction range" below. The reduction
range is always re-calculated after the machine data have been changed.
12–312
More user manuals on
Dynamic SW limit switches for following axes

Corresponding data

Dyn. SW limit switches for following axes
Software limit switches active
Deadtime compensation for dyn. SW limit switches
Minimum reduction factor for dyn. SW limit switches
Axis is in reduction range
Dynamic SW limit switch monitoring passive
Path speed of channel not reduced

Description of function

in the machine data. This braking path represents an area in front
max
Reduction range (V
ManualsBase.com
* V ) / 2 * A
max max max
© Siemens AG 1992 All Rights Reserved
08.96
and the
max
6FC5197- AA50
SINUMERIK 840C (IA)