Nidec Unidrive M200 User Manual page 97

Safety Product Mechanical
information information installation
Parameter
05.080 Low acoustic noise enable
Change to maximum drive switching fre-
05.081
quency at low output current
05.083 Voltage Shelving Disable
Low Frequency Slip Boost
05.084
Low Frequency Estimator Threshold
05.088 Ur Mode Pre-Flux Delay
* If this parameter is read via serial communications, it will show pole pairs.
RW Read / Write RO Read only
ND No default value NC Not copied
Unidrive M200 / M201 Control User Guide
Issue Number: 2
Electrical Getting Basic
installation started parameters
Range ()
OL
Off (0) or On (1)
Off (0) or On (1)
Off (0) or On (1)
0.0 to 100.0 %
0.0 to 0.7 s
Num Number parameter
PT Protected parameter
Running the NV Media
Optimization
motor Card
RFC-A OL
Off (0)
Off (0)
0.0 %
0.0 to 100.0 %
0.1 s
Bit Bit parameter Txt Text string
RA Rating dependent US User save
Onboard Advanced
Diagnostics
PLC parameters
Default ()
RFC-A
RW Bit
Off (0) RW Bit
RW Bit
RW Num
0.0 % RW Num
RW Num
Bin Binary parameter
PS Power-down save
UL Listing
Type
US
US
US
US
US
US
FI Filtered
DE Destination
97