Safety
Product
Mechanical
information
information
installation
Figure 3-5 Installing the AI-485 / AI-Backup Adaptor to the drive (AI-485 Adaptor shown)
•
Identify the two plastic fingers on the underside of the AI-485 / AI-Backup Adaptor (1) - then insert the two fingers into the corresponding slots in
the spring-loaded sliding cover on the top of the drive.
•
Hold the adaptor firmly and push the spring loaded protective cover towards the back of the drive to expose the connector block (2) below.
•
Press the adaptor downwards (3) until the adaptor connector locates into the drive connection below.
Figure 3-6 Removal of the AI-485 / AI-Backup Adaptor adaptor (AI-485 Adaptor shown)
•
To remove the AI-485 / AI-Backup Adaptor, pull it up away from the drive in the direction shown (1)
Unidrive M200 / M201 Control User Guide
Issue Number: 2
Electrical
Getting
Basic
installation
started
parameters
1
Running the
NV Media
Optimization
motor
Card
2
3
Onboard
Advanced
Diagnostics
PLC
parameters
UL Listing
17