Managing Static Vlans - Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Parameter
PVID
PVID Format
GVRP
4. Click Apply.
Section 5.2.5

Managing Static VLANs

The following sections describe how to configure and manage static VLANs:
• Section 5.2.5.1, "Viewing a List of Static VLANs"
• Section 5.2.5.2, "Adding a Static VLAN"
• Section 5.2.5.3, "Deleting a Static VLAN"
Managing Static VLANs
Description
• PVLANEdge - the port is only a member of one VLAN (its native VLAN specified by
the PVID parameter), and does not forward traffic to other PVLANedge ports within
the same VLAN.
• QinQ - the port is a trunk port using double-VLAN tagging, or nested VLANs. An extra
VLAN tag is always added to all frames egressing this port. VID in the added extra
tag is the PVID of the frame's ingress port. VLAN tag is always stripped from frames
ingressing this port.
NOTE
QinQ can only be enabled on one switch port at a time.
Synopsis: 1 to 4094
Default: 1
The Port VLAN Identifier specifies the VLAN ID associated with untagged (and 802.1p
priority tagged) frames received on this port.
Frames tagged with a non-zero VLAN ID will always be associated with the VLAN ID
retrieved from the frame tag.
Modify this parameter with care! By default, the switch is programmed to use VLAN 1 for
management and every port on the switch is programmed to use VLAN 1. If you modify
a switch port to use a VLAN other than the management VLAN, devices on that port will
not be able to manage the switch.
Synopsis: { Untagged, Tagged }
Default: Untagged
Specifies whether frames transmitted out of the port on its native VLAN (specified by the
PVID parameter) will be tagged or untagged.
If Type is set to QinQ, set the PVID format to Tagged and make sure all other ports are
set to Untagged.
Synopsis: { Adv&Learn, Adv Only, Disabled }
Default: Disabled
Configures GVRP (Generic VLAN Registration Protocol) operation on the port. There
are several GVRP operation modes:
• DISABLED - the port is not capable of any GVRP processing.
• ADVERTISE ONLY - the port will declare all VLANs existing in the switch (configured
or learned) but will not learn any VLANs.
• ADVERTISE & LEARN - the port will declare all VLANs existing in the switch
(configured or learned) and can dynamically learn VLANs.
Only Trunk ports are GVRP-capable.
Chapter 5
Setup and Configuration
133