Siemens RUGGEDCOM ROS User Manual page 191

RUGGEDCOM ROS
User Guide
1
Figure 120: Static MAC Addresses Table
1. InsertRecord
2. Click InsertRecord. The Static MAC Addresses form appears.
5
Figure 121: Static MAC Addresses Form
1. MAC Address Box
3. Configure the following parameter(s) as required:
Parameter
MAC Address
VID
Adding a Static MAC Address
2. VID Box 3. Port Box 4. CoS List
Description
Synopsis: ##-##-##-##-##-## where ## ranges 0 to FF
A MAC address learned by the switch.
Maximum of 6 wildcard characters may be used to specify a range of MAC addresses
allowed to be learned by the Port Security module (when Port Security is set to 'Static
MAC' mode). Wildcard must start from the right hand end and continuous.
Examples:
• 00-0A-DC-**-**-** means the entire MAC address space of RuggedCom.
• 00-0A-DC-12-3*-** means the range 00-0A-DC-12-30-00 to 00-0A-DC-12-3F-FF.
Synopsis: 1 to 4094 or { ANY }
Default: 1
VLAN Identifier of the VLAN upon which the MAC address operates.
Option ANY allows learning a MAC address through the Port Security module on any
VLAN's that are configured on the switch.
6
5. Apply Button 6. Delete Button
Chapter 5
Setup and Configuration
1
2
3
4
7
7. Reload Button
177