Siemens RUGGEDCOM ROS User Manual page 131

RUGGEDCOM ROS
User Guide
NOTE
The RADIUS client uses the Password Authentication Protocol (PAP) to verify access.
To configure access to either the primary or backup RADIUS servers, do the following:
Navigate to Administration » Configure Security Server » Configure RADIUS Server. The RADIUS
1.
Server table appears.
Figure 72: RADIUS Server Table
2. Select either Primary or Backup from the table. The RADIUS Server form appears.
6
Figure 73: RADIUS Server Form
1. Server Box
7. Reload Button
3. Configure the following parameter(s) as required:
Parameter
Server
IP Address
Auth UDP Port
Auth Key
Configuring the RADIUS Client
2. IP Address Box 3. Auth UDP Port Box
Description
Synopsis: Any 8 characters
Default: Primary
This field tells whether this configuration is for a Primary or a Backup Server.
Synopsis: ###.###.###.### where ### ranges from 0 to 255
The Server IP Address.
Synopsis: 1 to 65535
Default: 1812
The IP Port on server.
Synopsis: 31 character ASCII string
The authentication key to be shared with server.
4. Auth Key Box 5. Confirm Auth Key Box
Chapter 4
System Administration
1
2
3
4
5
7
6. Apply Button
117