Deleting A Static Multicast Group; Managing Port Security - Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
4. Click Apply.
Section 5.9.7.3

Deleting a Static Multicast Group

To delete a static multicast group, do the following:
1. Navigate to Multicast Filtering » Configure Static Multicast Groups. The Static Multicast Groups table
appears.
Figure 162: Static Multicast Groups Table
2. Select the group from the table. The Static Multicast Groups form appears.
5
Figure 163: Static Multicast Groups Form
1. MAC Address Box
3. Click Delete.
Section 5.10

Managing Port Security

Port security, or port access control, provides the ability to filter or accept traffic from specific MAC addresses.
Port security works by inspecting the source MAC addresses of received frames and validating them against
the list of MAC addresses authorized by the port. Unauthorized frames are filtered and, optionally, the part
Deleting a Static Multicast Group
2. VID Box 3. Priority Box
6
4. Ports Box 5. Apply Button
Setup and Configuration
6. Delete Button 7. Reload Button
Chapter 5
1
2
3
4
7
215