Siemens RUGGEDCOM ROS User Manual page 183

RUGGEDCOM ROS
User Guide
Figure 109: Port CoS Parameters Table
2. Select an Ethernet port. The Port CoS Parameters form appears.
4
Figure 110: Port CoS Parameters Form
1. Port(s) Box
3. Configure the following parameter(s) as required:
Parameter
Port(s)
Default Pri
Inspect TOS
Configuring Classes of Service for Specific Ethernet Ports
2. Default Pri Box 3. Inspect TOS Options
Description
Synopsis: Any combination of numbers valid for this parameter
The port number as seen on the front plate silkscreen of the switch (or a list of ports, if
aggregated in a port trunk).
Synopsis: 0 to 7
Default: 0
This parameter allows to prioritize frames received on this port that are not prioritized
based on the frames contents (e.g. priority field in the VLAN tag, DiffServ field in the IP
header, prioritized MAC address).
Synopsis: { No, Yes }
Default: No
This parameters enables or disables parsing of the Type-Of-Service (TOS) field in the
IP header of the received frames to determine what Class of Service they should be
assigned. When TOS parsing is enabled the switch will use the Differentiated Services
bits in the TOS field.
4. Apply Button 5. Reload Button
Chapter 5
Setup and Configuration
1
2
3
5
169