Siemens RUGGEDCOM ROS User Manual page 80

Chapter 3
Device Management
11
Figure 26: Port Parameters Form
1. Port Box 2. Name Box
Box 10. Alarm Box
3. Configure the following parameter(s) as required:
Parameter
Port
Name
Media
State
AutoN
66
3. Media Box 4. State Box
11. Apply Button 12. Reload Button
Description
Synopsis: 1 to maximum port number
Default: 1
The port number as seen on the front plate silkscreen of the switch.
Synopsis: Any 15 characters
Default: Port x
A descriptive name that may be used to identify the device connected on that port.
Synopsis: { 100TX, 10FL, 100FX, 1000X, 1000T, 802.11g, EoVDSL, 100TX Only,
10FL/100SX, 10GX }
Default: 100TX
The type of the port media.
Synopsis: { Disabled, Enabled }
Default: Enabled
Disabling a port will prevent all frames from being sent and received on that port. Also,
when disabled link integrity signal is not sent so that the link/activity LED will never be
lit. You may want to disable a port for troubleshooting or to secure it from unauthorized
connections.
Synopsis: { Off, On }
Default: On
Enable or disable IEEE 802.3 auto-negotiation. Enabling auto-negotiation results in
speed and duplex being negotiated upon link detection; both end devices must be auto-
negotiation compliant for the best possible results. 10Mbps and 100Mbps fiber optic
5. AutoN Box 6. Speed Box
NOTE
Disabling a port whose media type is set to 802.11g disables the
corresponding wireless module.
RUGGEDCOM ROS
User Guide
7. Dupx Box 8. FlowCtrl Box
Configuring an Ethernet Port
1
2
3
4
5
6
7
8
9
10
12
9. LFI