Viewing A List Of Snmp Groups; Adding An Snmp Group - Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Section 5.7.3.1

Viewing a List of SNMP Groups

To view a list of SNMP groups configured on the device, navigate to Administration » Configure SNMP »
Configure SNMP Access. The SNMP Access table appears.
Figure 138: SNMP Access Table
If SNMP groups have not been configured, add groups as needed. For more information, refer to
"Adding an SNMP Group".
Section 5.7.3.2

Adding an SNMP Group

To add an SNMP group, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Access. The SNMP Access table
appears.
1
Figure 139: SNMP Access Table
1. InsertRecord
Click InsertRecord. The SNMP Access form appears.
2.
Viewing a List of SNMP Groups
Chapter 5
Setup and Configuration
Section 5.7.3.2,
191