Managing Snmp Users; Viewing A List Of Snmp Users - Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Before configuring SNMPv3, note the following:
• Each user belongs to a group
• A group defines the access policy for a set of users
• An access policy defines what SNMP objects can be accessed for (i.e. reading, writing and creating
notifications)
• A group determines the list of notifications its users can receive
• A group also defines the security model and security level for its users
For SNMPv1 and SNMPv2c, a community string can be configured. The string is mapped to the group and
access level with a security name, which is configured as User Name.
The following sections describe how to setup and manage SNMP on the device:
• Section 5.7.1, "Managing SNMP Users"
• Section 5.7.2, "Managing Security-to-Group Mapping"
• Section 5.7.3, "Managing SNMP Groups"
Section 5.7.1

Managing SNMP Users

The following sections describe how to configure and manage SNMP users, refer to the following:
• Section 5.7.1.1, "Viewing a List of SNMP Users"
• Section 5.7.1.2, "Adding an SNMP User"
• Section 5.7.1.3, "Deleting an SNMP User"
Section 5.7.1.1

Viewing a List of SNMP Users

To view a list of SNMP users configured on the device, navigate to Administration » Configure SNMP »
Configure SNMP Users. The SNMP Users table appears.
Figure 128: SNMP Users Table
If users have not been configured, add users as needed. For more information, refer to
an SNMP User".
Managing SNMP Users
Chapter 5
Setup and Configuration
Section 5.7.1.2, "Adding
183