Replacing The O-Rings; Figure 5-5. Water Trap Probe Assembly - Filter And O-Ring Replacing - Thermo Scientific TVA2020 Instruction Manual

Preventive Maintenance
Replacing Water Trap Probe Filter and O-Rings
Replacing the
5-12 TVA2020 Instruction Manual
Use the following procedure to replace the o-rings
O-Rings
1. Unscrew the bottom housing from the top housing.
2. Remove filter.
3. Remove o-ring from either top housing groove or bottom housing
groove or both as necessary.
4. Place new o-ring in groove of housing. Make sure o-ring is seated
properly in groove.
5. Repeat for other housing if necessary.
6. Place filter into top housing.
7. Screw bottom housing into top housing.
Nozzle Base
Figure 5–5. Water Trap Probe Assembly – Filter and O-Ring Replacing
O-ring
Water trap
O-ring
(Figure
Nozzle
5–5).
Thermo Fisher Scientific