Configuring Source Ipv6 Addresses For Mld Messages - HPE FlexNetwork 5130 EI Series Configuration Manual

Configuring source IPv6 addresses for MLD messages

Changing the source IPv6 address of MLD queries might affect MLD querier election within the
subnet.
To configure the source IP address for MLD queries in a VLAN:
Step
1. Enter system view.
2. Enter VLAN view.
3. Configure the source IPv6
address for MLD general
queries.
4. Configure the source IPv6
address for MLD
multicast-address-specific
queries.
5. Configure the source IPv6
address for MLD reports.
6. Configure the source IPv6
address for MLD done
messages.
Command
system-view
vlan vlan-id
mld-snooping general-query
source-ip ipv6-address
mld-snooping special-query
source-ip ipv6-address
mld-snooping report source-ip
ipv6-address
mld-snooping done source-ip
ipv6-address
65
Remarks
N/A
N/A
The default setting is the IPv6
link-local address of the current
VLAN interface. If the current
VLAN interface does not have an
IPv6 link-local address, the
source IPv6 address is
FE80::02FF:FFFF:FE00:0001.
By default, the source IPv6
address of MLD
multicast-address-specific
queries is one of the following:
•
The source address of MLD
general queries if the MLD
snooping querier has
received MLD general
queries.
•
The IPv6 link-local address
of the current VLAN interface
if the MLD snooping querier
does not receive an MLD
general query.
•
FE80::02FF:FFFF:FE00:000
1 if the MLD snooping
querier does not receive an
MLD general query and the
current VLAN interface does
not have an IPv6 link-local
address.
The default setting is the IPv6
link-local address of the current
VLAN interface. If the current
VLAN interface does not have an
IPv6 link-local address, the
source IPv6 address is
FE80::02FF:FFFF:FE00:0001.
The default setting is the IPv6
link-local address of the current
VLAN interface. If the current
VLAN interface does not have an
IPv6 link-local address, the
source IPv6 address is
FE80::02FF:FFFF:FE00:0001.