Installing New Hfa Ii Software - Zeiss HUMPHREY 720i User Manual

APPENDIX A
Appendix F: Installing New HFA II Software
Backup all data first
Identify the current software
If you have trouble
installing your new
software
REV. B 02/03 PN 51680-1 R E V . A 10 9/ 9 8 P N 47653
lease take a moment to read the following information before attempting to install any new
P
HFA II software.
Make sure you have backed up (made copies of) all of your data. You should be
careful to ensure you have copies of all your data on either floppy disks or magneto-optical
disks. Refer to Section 9: "Database Management" for instructions on how to back up your
data.
Identify the software your instrument is currently running. Turn on your instrument and allow
it to warm up. In the upper, left-hand corner of the Main Menu screen, the software revision
will be identified (e.g. "Rev. C_X ").
If a system error occurs during any part of the installation process:
1. Remove the floppy disk from the disk drive and power down the unit (turn HFA off).
2. Repeat the installation process starting at Step 1 (see next page).
If the system failure occurs a second time, change the write-protection status of the floppy
disk(s). Some installations cannot proceed with a write-protected disk.
If you continue to have difficulties, call Carl Zeiss Meditec Customer Service at 1-877-486-7473
(1-877-HUMPHREY) to obtain advice or a new set of software.
HUMPHREY FIELD ANALYZER II - H U M P H R E Y F I E L D A N A L Y Z E R
HUMPHREY FIELD ANALYZER II
A-17 F-1
i I I
series