Zeiss HUMPHREY 720i User Manual page 259

KINETIC TESTING
REV. B 02/03 PN 51680-1
This is the initial screen for creating the Custom Kinetic test. The stimulus information is
displayed in the upper-right corner. If desired, the stimulus speed may be altered for each
meridian to be tested by using the Speed pull-down menu located in the upper-left corner.
7
To enter the first meridian,
press ADD MERIDIAN.
8
The Keypad will appear on
the screen. Enter the
meridian desired (eligible range
is 0 - 359 degrees).
Note: You may find it more
convenient to use the Cursor
method (as described earlier in
this section) when choosing the
points.
9
A small gray square will be
placed on the meridian
entered. In this example, the
square can be seen on the 60
degree meridian. The meridian is
displayed at the right.
Continue to add the meridians to
be tested by repeating the above
steps.
HUMPHREY FIELD ANALYZER II - i series
11-51