3-18
Entering Cup/Disk (C/D) ratios
REV. B 02/03 PN 51680-1
1
From the Patient Data 2 screen, choose HORIZONTAL C/D (cup/disk ratio).
2
Enter a decimal point
and up to 2 characters
(.00-.99) from the pop-up
keypad, then ENTER.
3
Repeat for the other eye.
4
Repeat Steps 1-3 to enter a VERTICAL C/D.
When you have finished entering data on the Patient Data 2 screen and are ready to test,
choose PROCEED. This takes you to the test screen where you can set test parameters, if
desired, before beginning the test (see Section 4).
Here is an example of a Patient Data 2 screen with a number of completed data fields. Remember,
completing every field is not required for each patient. Refer to "Entering Patient Data".
Figure 3.3: A Completed Patient Data 2 Screen
SETTING-UP TESTS
HUMPHREY FIELD ANALYZER II -
i
series