Throttle Mode Check; Trims Initial Set-Up - FUTABA 4PV Instruction Manual

Throttle Mode Check

The throttle servo travel can be set to 5:5 or 7:3 for throttle trigger operation as required by
the throttle mode function (page 88).

Trims Initial Set-Up

- Steering trim (DT1) check
On the initial set-up, steering trim is assigned to the DT1 trim lever upper right side of the
steering wheel. Operate the DT1 and make sure the marker moves on the ST graph. If de-
fault has been changed, test steering trim in its new location. After checking the trim, set
the trim display to the center (N) position.
- Throttle trim (DT2) check
On the initial set-up, throttle trim is assigned to the DT2 trim lever upper left side of the
steering wheel. Operate the DT2 and make sure the marker moves on the TH graph. If the
default has been changed, test the throttle trim in its new location. After checking the trim,
set the trim display to the center (N) position.
Throttle trim (DT2)
4PV-Eng-06-Initl_set-P33-38.indd 37
F5/B5
5 : 5
Forward side
F5/B5 or F7/B3
Steering trim (DT1)
Brake side Forward side
F7/B3
7 : 3
Brake side
Steering trim
Throttle trim
37
2016/08/05 9:00:40