Adjuster "Adjuster - FUTABA 4PV Instruction Manual

Adjuster "ADJUSTER"

Steering wheel and throttle trigger neutral position and servo operating angle correction can
be applied. This is used when a mechanical offset has occurred for some reason.
*However, when correction is made, the set value of all the setting functions must be
rechecked.
Display the " ADJUSTER " screen using the following method:.
(HOME screen)
Press
Steering adjustment
(Preparation)
On the ADJUSTER screen, select the setting item "WHEEL"
by moving the (JOG) button up or down, and press the (JOG)
button.
1
(Steering neutral adjustment)
In the neutral setup screen (fi g-1) state, lightly pull the steering
wheel and then press the (JOG) button without touching the
wheel.
2
(Steering throw adjustment)
In the throw setup screen state (fi g-2), lightly turn the wheel
fully to the left or right and when button mark (fig-3) is dis-
played, press the (JOG) button.
Internal check is performed automatically. When each adjust-
ment point is within a fi xed range, correction is performed and
"COMPLETE" (fi g-4) is displayed.
If an adjustment point is not within a fi xed range, correction is
not performed and the correction data is not updated.
When button mark is not displayed even though correction was
performed again, please contact a Futaba Radio Control Cus-
tomer Center.
3
When fi nished with setting, return to the ADJUSTER screen by
pressing the (END) button.
4PV-Eng-08-3-Function-P93-128.indd 127
(MENU 1) (MENU 3)
(MENU 2)
Adjuster "ADJUSTER"
(ADJUSTER screen)
Press
Select
"ADJUSTER"
Press
fi g-1
fi g-2
fi g-4
fi g-3
127
2016/08/05 10:13:24