S.bus Link Function "Sx Link - FUTABA 4PV Instruction Manual

S.BUS Link Function "SX LINK"

This is a special function which allows Futaba S.BUS/S.BUS2 servo parameter changes
to be set by the T4PV transmitter.
However, some data changes require a PC and S-Link software.
This function is used by connecting Futaba S.BUS/S.BUS2 servos directly to the trans-
mitter.
Use the various optional servo extension cords according to the distance between the
transmitter and servo.
-When the T4PV battery voltage drops, the display switches to low battery display. Therefore, use this function when there is am-
ple battery capacity remaining.
-Also connect the corresponding battery to the servo side.
Display to " SX LINK " screen using the following method:
(HOME screen)
4PV-Eng-08-3-Function-P93-128.indd 93
(MENU 1 )
(MENU 2 )
Press
Setup item
READ
WRITE :Writing the data to servo.
RESET :Initialization
S.BUS Link Function "SX LINK"
Connect the S.BUS servo and
the batteries to the transmitter
Communication port .
(MENU 3 )
Select
"SX LINK"
:Servo's data read.
Battery
(SX LINK screen)
Press
Press
2016/08/05
93
10:13:18