FUTABA 4PV Instruction Manual page 94

Using the S.BUS servo function
(Preparation)
- Connect the T4PV and S.BUS or S.BUS2 servo in accordance
with the connection diagram shown on page 93.
- Connect the battery to S.BUS/S.BUS2 servo.
1
Display the SX LINK function screen referring on page 93.
2
(S.BUS/S.BUS2 servo read)
Execute this function to read the connected servo's ID and the
data currently set at the servo.
Select the setting item "MODE" by moving the(JOG) button up
or down. Select "READ" by (+) or (-) button, and press the (JOG)
button.
-"COMPLETE!" blinks on the screen and the servo ID and currently set contents are
read.
- If "COM-ERROR" blinks on the screen, communication with the servo is not being
performed normally. Check the T4PV and servo connection and the battery connection
to servo and repeat READ.
3
(Writing to S.BUS/S.BUS2)
Execute this function to write the setting data to the servo.
See pages 95~96 for the setting data contents.
Select the setting item "MODE" by moving the (JOG) button
up or down. Select "WRITE" by (+) or (-) button, and press the
(JOG) button.
-"COMPLETE!" blinks on the screen and the setting data is written to the servo.
-If "COM-ERROR" blinks on the screen, communication with the servo is not being
performed normally. Check the T4PV and servo connection and the battery connection
to ESC and the ESC power switch and repeat WRITE. In addition, if (NO DATA) is dis-
played on the T4PV screen, "WRITE" cannot be selected because there is no setting data
to be written.
4
(Initialization)
This function writes the servo setting data set at the factory to
the connected servo. Perform "READ" before performing initial-
ization.
Select the setting item "MODE" by moving the (JOG) button
up or down. Select "RESET" by (+) or (-) button, and press the
(JOG) button.
- "COMPLETE!" blinks on the screen and the initial data is written to the servo. If
"COM-ERROR" blinks, communication with the servo was not performed normally.
Check the T4PV and servo connection and the battery connection to servo, and repeat
RESET, when (NO DATA) is displayed on the T4PV screen "RESET" cannot be se-
lected because there is no write initial data.
94
4PV-Eng-08-3-Function-P93-128.indd
S.BUS Link Function "SX LINK"
94 2016/08/05 10:13:18