FUTABA 4PV Instruction Manual page 81

2.4ghz t-fhss telemetry system
Table of Contents

Advertisement

1
(4WS type selection)
Select the setting item "MODE" by moving the
(JOG) button up or down. Use the (+) or (-) and
set the function to the "ON" or "OFF" state.
"INH"
:Function OFF (front only).
"2TYP" :Front side only, reverse phase switching.
"3TYP" :Front side only, reverse phase and same phase switching.
"4TYP" :Front side only, reverse phase, same phase, and rear side
only switching.
- When "(GYRO MIX ACT → INH)" is displayed, the 4WS cannot be used if the GY-
RO MIX function is not set to "INH".
- When "(BRAKE CH3 ACT → INH)" is displayed, the 4WS cannot be used if the
BRAKE MIX (CH3) function is not set to "INH".
Switched in the order shown in the fi gure below by set SW (PS2).
"2TYP":Front side only and reverse
phase switching
"4TYP":Front side only, reverse phase, same phase, and rear side only switching
2
(Rear side travel adjustment)
Select setting item "RATE" by moving the (JOG) button up or
down. Adjust the rear side travel with the (+) or (-) button.
3
(Mix mode setting)
Select setting item "MXMD" by moving the (JOG) button up or
down. Set the mix mode with the (+) or (-) button.
"OFF" :The EXP function of the 1st CH and other settings are not mixed.
"ON"
:The EXP function o the 1st CH and other settings are mixed.
4
When finished with setting, return to the MENU screen by
pressing the (END) button.
4PV-Eng-08-2-Function-P70-92.indd
81
"3TYP":Front side only, reverse phase, and same phase switching
4WS Mixing "4WS"
< NO SW >
Displayed when the 4WS
type SW is not used.
The function select switch
screen (p.72) can be dis-
played from this screen.
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Select button
- Select with the (+) or (-) but-
tons.
Rear rate (RATE)
0 ~ 100
Initial value:100
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Select button
- Select with the (+) or (-) but-
tons.
2016/08/05
81
9:41:38

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents