FUTABA 4PV Instruction Manual page 83

The programmed DT button is used to select the drive type as
shown in the fi gure below.
2
(Rear side travel adjustment)
Select the setting item "RATE" by moving the (JOG) button up
or down. Use when applying a rotation difference to the front
and rear wheels by adjusting the rear (CH4) motor controller
travel with the (+) or (-) button.
3
(Mix mode setting)
Select the setting item "MXMD" by moving the (JOG) button up
or down. Set the mix mode with the (+) or (-) button.
"OFF" : CH2 EXP function and other settings are not mixed.
"ON" : CH2 EXP function and other settings are mixed.
4
(Trim mode setting)
Select the setting item "TRIM" by moving the (JOG) button up
or down. Set the trim mode with the (+) or (-) button.
"OFF" : Front side (CH2) trim data is not included.
"ON" : Front side (CH2) trim data is included.
5
When finished with setting, return to the MENU screen by
pressing the (END) button.
Dial / Trim Setting
The function select dial function can control the 4th channel's ESC (Rear side) rate
(RATE) with digital dial or digital trim, using the function select trim dial function (See
page 70).
Note:
As this function drives 2 separate motor controllers simultaneously, a mutual load is
applied. Use this function carefully so that the motor controllers are not damaged. Fut-
aba will not be responsible for motor controller, motor, and other vehicle trouble due to
use of this function.
4PV-Eng-08-2-Function-P70-92.indd 83
Dual ESC Mixing "DUAL ESC"
Rear rate (RATE)
0 ~ 120
Initial value:100
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Select button
- Select with the (+) or (-) but-
tons.
Trim mode (TRIM)
OFF, ON
Initial value: OFF
Select button
- Select with the (+) or (-) but-
tons.
2016/08/05
83
9:41:39