Neutral Brake "Ntbrk - FUTABA 4PV Instruction Manual

Neutral Brake "NTBRK"

be set (see page 72).
be set. However, when using the MC950CR, MC851C, MC602C, MC402CR, or other Futa-
ba ESC
In addition, when the idle up function or throttle off function (p.91) is set, this function has
Reference
Dial / Trim Setting
matically assigned to the throttle trim (DT1 - DT6 or DL1).
Operation display
< NO SW >
If function's ON/OFF switch
is not selected, <NO SW>
is displayed.
The function select switch
screen (p.72) can be dis-
played from this screen.
Neutral Brake function adjustment
(Preparation)
- Use the function select switch to select the switch. (p.72)
1
(Neutral brake rate)
Select the setting item "NTBRK" by moving the (JOG) button
up or down. Use the (+) and (-) buttons to set the neutral brake
rate.
2
When finished with setting, return to the MENU screen by
pressing the (END) button.
Effect of set value of other functions on neutral brake
operation.
90
4PV-Eng-08-2-Function-P70-92.indd 90
ON , the neutral
" "
If the power switch is
turned on while the neu-
an audible alarm will be
heard. Immediately set
to OFF.
Throttle Mode "TH MODE"
Warning display
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Brake rate (NTBRK)
0 ~ B100
Initial value: 0
2016/08/05 9:41:39