Throttle Off (Engine Cut) "Thoff - FUTABA 4PV Instruction Manual

Throttle Off (engine cut) "THOFF"

This is a function select switch function. The throttle off function ON/OFF switch must be
set (see page 72).
The engine cut function stops the engine of a boat, etc. by operating the throttle servo to the
slow side by switch regardless of the position of the throttle trigger and the setting of other
functions (reverse function setting is effective).
Dial / Trim Setting
The function select dial function can control the throttle-off position can be controlled
with digital dial or digital trim (See page 70).
Operation display
< NO SW >
If function's ON/OFF switch
is not selected, <NO SW>
is displayed.
The function select switch
screen (p.72) can be dis-
played from this screen.
Engine Cut function adjustment
(Preparation)
- Use the function select switch to select the switch. (p.72)
1
(Preset position setup)
- Select the setting item "THOFF" by moving the (JOG) button
up or down. Use the (+) and (-) buttons to set the preset posi-
tion of the throttlle servo.
2
When finished with setting, return to the MENU screen by
pressing the (END) button.
Caution
Always operate carefully before using this function.
While switch with preset function set is in the ON state, the servo (motor controller) is locked in the preset posi-
tion and does not operate even if the throttle trigger is operated. If the servo is operated at the wrong setting,
you may lose control of the car (boat).
4PV-Eng-08-2-Function-P70-92.indd 91
If the power switch is
t u r ned on wh ile t he
throttle-off switch is on,
an audible alarm will be
heard. Immediately set
the throttle off switch to
OFF.
Throttle Mode "TH MODE"
Warning display
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Preset position (THOFF)
0 ~ B100
Initial value: 0
2016/08/05
91
9:41:40