Receiver Mode Precautions - FUTABA T10PX Quick Start Manual

4
Bring the transmitter and receiver within 50 cm of each other (antennas do not touch) and turn on the
receiver power.
5
Touch [Link] on the transmitter T10PX screen, you will hear a chime sound and T10PX will enter the
link mode for 20 seconds.
6
During the 20 seconds link mode, press the receiver for at least 2 seconds. The LED blinks red and
then changes to a greenish red
the message "Link with receiver" appears on the screen, release the receiver push switch. This ends
reading of mutual ID and displays the memorized receiver ID number on the T10PX screen. Power
cycle the receiver. If the "Receiver not found" error screen is displayed, linking failed. Check the set
contents and repeat the linking operation.
7
Once the settings are complete, turn the receiver off and then on again. The response and battery fail-
safe voltage settings will take effect after the receiver is restarted.
Caution
Be sure to use the T10PX receiver setting and the servo to be used under predetermined conditions.
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates. In addition, it
may cause servo trouble. Futaba will not be responsible for problems caused by the use of other than genuine Futaba parts. Use the
parts specified in the instruction manual and catalog.
System Receiver
R404SBS
R404SBS-E
R334SBS
R334SBS-E
R324SBS R324SBS
R314SB R314SB
R314SB-E R314SB-E
R304SB R304SB
R304SB-E R304SB-E
R202GF
R203GF
R204GF-E
R214GF-E
R2104GF
● For servos for which the operation mode can be set, change the servo operation mode according to the system to be used. If the operating modes
of the system and servo are different, it will fail.
● Use UR servo（Set to UR mode） for UR mode. Use SR/UR servo（Set to SR mode） for SR mode.
● When the UR(SR) mode is ON, it is exclusively for our UR(SR) compatible servo. Using a servo other than the UR(SR) compatible servo may
cause the servo or receiver to malfunction.
● If a normal servo is connected to a CH with UR/SR mode ON, there is a risk of damage.
● Do not connect UR/SR servo (set to UR/SR mode) and analog servo in digital servo mode.
● Do not connect UR/SR servo (set to UR/SR mode) in analog servo mode.
● UR/SR servo can be used digital or analog when set to normal mode.
● Connecting an UR/SR mode compatible servo set to UR/SR mode to the S (S.BUS2 port) may cause malfunction of the servo or receiver.
● Receiver battery: Matched to the ratings of the receiver and connected servo (dry cell battery cannot be used).
● Fail-safe Unit cannot be used because the system is different. Use the fail-safe function of the transmitter.
green steady light. When the T10PX makes a beeping sound and

Receiver Mode Precautions

Response
UR mode ・Futaba UR servo
SR mode ・ Futaba SR servo
Digital servo ・Futaba Digital servo
Analog servo ・Futaba Digital servo/Analog servo
SR mode channel ON ・Futaba SR servo
SR mode channel OFF ・Futaba Digital servo
Digital servo ・Futaba Digital servo
Analog servo ・Futaba Digital servo/Analog servo
Usable servo