Cps Mixing "Cps Mix - FUTABA 4PV Instruction Manual

CPS Mixing "CPS MIX"

This function controls the Futaba CPS-1 channel power switch.
Normally, when using the CPS-1 unit to operate vehicle lighting systems, the CPS-1 unit
with LED connected is connected to a vacant switch channel and the LEDs are turned on
and off by switch while the vehicle is running. However, when the CPS-1 mixing (CPS
can also be set.
Setting Special Mixes
and Dual ESC Mixing (p.82) are used, this CPS Mixing function cannot be used.
Display " CPS MIX " screen using the following method:
(HOME screen)
CPS mixing adjustment
(Preparation)
- Connect the CPS-1 to the 4th CH of the receiver.
- When the LEDs are turned on and off by switch, use the func-
tion select switch function (p.72) to set the switch to be used.
86
4PV-Eng-08-2-Function-P70-92.indd 86
(MENU 1)
(MENU 3)
Press
Setup items
MODE : Function ON/OFF, control mode
POSI : ON/OFF position
TYPE : ON/OFF type
TCYCL : Flashing speed
CPS Mixing "CPS MIX"
(MENU 2)
Press
Select
"CPS MIX"
Function SW
(CPS MIX screen)
Press
CH4
2016/08/05 9:41:39