Trigger Slide Adjustment - FUTABA 4PV Instruction Manual

Trigger Slide Adjustment

The throttle trigger position can be moved forward and backward.
Adjustment
1
Using a 2.0mm hex wrench, loosen the trigger
slide mounting screw by turning it slightly counter-
clockwise.
Always loosen this screw.
Note:
If the trigger slide screw is turned
too much, the screw may fall out.
2
Using a 2.5mm hex wrench, turn the trigger slide
adjusting screw, and adjust the trigger slide posi-
tion within the marked range. When the adjusting
screw is turned clockwise, the trigger slide moves
away from the grip handle.
3
Retighten the mounting screw loosened at step 1
and fasten the trigger slide.
4PV-Eng-04-Before-P12-28.indd 23
Trigger slide
Adjust so that the bottom
mounting screw
mark does not exceed
the top marking line.
23
2016/08/02 9:06:10