Advertisement

Quick Links

Before using your 2PL-FM, read this manual carefully and use your R/C set safely.
After reading this manual, store it in a safe place.
Application, Export, and Modification
1. This product may be used for models only. It is not intended for use in any application other than the
control of models for hobby and recreational purposes. The product is subject to regulations of the
Ministry of Radio/Telecommunications and is restricted under Japanese law to such purposes.
2. Exportation precautions:
(a) When this product is exported from the country of manufacture, its use is to be approved by the
laws governing the country of destination which govern devices that emit radio frequencies. If this
product is then re-exported to other countries, it may be subject to restrictions on such export. Prior
approval of the appropriate goverment authorities may be required. If you have purchased this product
from an exporter outside your country, and not the authorized Futaba distributor in your country,
please contact the seller immediately to determine if such export regulations have been met.
(b) Use of this product with other than models may be restricted by Export and Trade Control Regula-
tions, and an application for export approval must be submitted. In the US, use of 72MHz (aircraft
only), 75MHz (ground models only) and 27MHz (both) frequency bands are strictly regulated by the
FCC. This equipment must not be utilized to operate equipment other than radio controlled models.
Similarly, other frequencies (except 50MHz, for HAM operators) must not be used to operate models.
3. Modification, adjustment, and replacement of parts: Futaba is not responsible for unauthorized
modification, adjustment, and replacement of parts on this product. Any such changes may void the
warranty.
Compliance Information Statement (for U.S.A.)
This device, trade name Futaba Corporation of America, model number R153F complies with part 15
of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
The responsible party of this device compliance is;
Futaba Corporation of America
2865 Wall Triana Highway, Huntsville, Alabama 35824, U.S.A.
TEL (256) 461 - 7348
Battery Recycling (for U.S.A.)
TM
The RBRC
Futaba products indicates that Futaba Corporation of America is voluntarily participating
in an industry program to collect and recycle these batteries at the end of their useful
lives, when taken out of service within the United States. The RBRC
a convenient alternative to placing used nickel-cadmium batteries into the trash or mu-
nicipal waste system, which is illegal in some areas.
You may contact your local recycling center for information on where to return the spent battery.
Please call 1-800-8-BATTERY for information on Ni-Cd battery recycling in your area. Futaba Cor-
poration of America's involvement in this program is part of its commitment to protecting our environ-
ment and conserving natural resources.
NOTE: Our instruction manuals encourage our customers to return spent batteries to a local recycling
center in order to keep a healthy environment.
TM
RBRC
is a trademark of the Rechargeable Battery Recycling Corporation.
Warning: This product contains a chemical known to cause cancer and birth defects (or other
reproductive harm).
•No part of this manual may be reproduced in any form without prior permission.
•The contents of this manual are subject to change without prior notice.
•This manual has been carefully written. Please write to Futaba if you feel that any corrections or clarifications should
be made.
•Futaba is not responsible for the use of this product.
Thank you for purchasing a Futaba 2PL-FM.
SEAL on the (easily removable) nickel-cadmium battery contained in
TM
program provides

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2PL-FM and is the answer not in the manual?

Questions and answers

Summary of Contents for FUTABA 2PL-FM

  • Page 1 •No part of this manual may be reproduced in any form without prior permission. •The contents of this manual are subject to change without prior notice. •This manual has been carefully written. Please write to Futaba if you feel that any corrections or clarifications should be made.
  • Page 2: Table Of Contents

    Throttle End Point Adjustment (EPA-CH2) ..............14 ABS function (ABS-CH2) ....................14 Model Name (NAME) ......................14 MC230CR/MC330CR......................15 Flow Chart of 2PL-FM Functions ..........16 *Each function is easily selected with the SELECT key and set with the digital trim DT1/DT2. Reference ................... 18 Ratings ..........................
  • Page 3: Safety Precautions

    Safety Precautions For your safety as well as that of others, please read this manual thoroughly prior to instal- lation and operation of your digital proportional R/C system. Definition of Symbols The following defines the symbols used in this manual. Explanation of Symbols Procedures which may lead to a dangerous condition and cause Danger...
  • Page 4: Running Safety Precautions

    Running (Sailing) Safety Precautions Warning Conduct Tests Prior to operation always perform a range test. Even one abnormality in the R/C system may cause loss of control. [Range Test Procedure] Have a friend hold the model, or place on a stand where the wheels or prop can not come in contact with any object.
  • Page 5: Storage And Disposal Safety Precautions

    Prohibited Do not operate when you are tired, not feeling well or under the influence of alcohol or drugs. Your judgment is impaired and could result in a dangerous situation that may cause serious injury to yourself and others. Before you turn on the power switch on the transmitter, always check to see that the trigger is at the neutral position.
  • Page 6: Other Safety Precautions

    Always use only genuine Futaba receivers, servos, and electronic speed controls, along with other optional parts and components. Futaba will not be held responsible for damages caused by other than genuine Futaba parts and components. Use only genuine Futaba parts and components listed in the instruction manual and catalog.
  • Page 7: Before Operation

    Before Operation System Contents After opening the container, check the contents for the following items. The contents will vary with the system purchased. 2PL-FM System Contents Transmitter T2PL-FM (x1) R153F (x1) Receiver S3003 (x2) Servo S3003 (x1) MC230CR (x1) E.S.C.
  • Page 8: Nomenclature / Handling

    Nomenclature / Handling Transmitter T2PL-FM Antenna (*1) (*1) Throttle Trim Lever (DT2) Steering Trim Lever (DT1) Adjusts the throttle in small increments so the Adjusts the steering in small increments so model will not move at neutral. the model will run straight. Select Button (SELECT) Press the Select button to select the Power Switch...
  • Page 9 Handling Procedure for Bat- Caution teries (8 AA Size Batteries) Always be sure you reinsert the bat- (Battery Replacement Method) teries in the correct polarity order. If the batteries are loaded incorrectly , the Remove the battery cover from the transmitter may be damaged.
  • Page 10: Assembly / Adjustment

    Assembly / Adjustment Receiver and Servo Connection As you connect the receiver, servos and other components, do so in accordance with the "Assembly Precautions". Connections when a E.S.C. MC230CR or MC330CR are used. Connects to Motor Connects to Battery E.S.C. Steering Servo Receiver Power Switch...
  • Page 11 Use only genuine Futaba crystal sets as specified in this instruction manual. The use of other than Futaba crystal sets will result in decrease of range as well as loss of control. There are separate crystals for the Transmitter and Receiver. There are also crystal sets for AM, FM and Dual Conversion FM.
  • Page 12: Transmitter Set-Up Procedures

    Transmitter Set-Up Procedures *When making these settings adjustments, do so with the motor disconnected or the engine not running. (Preparations) Select the model memory that is not used and reset it to the initial values with the model selection and model reset functions. Model Selection Model Reset Push the DT2 lever up or down for about one second. Model number All data stored in the current (1 - 0)...
  • Page 13: Description Of 2Pl-Fm Functions

    Description of 2PL-FM Functions Steering Trim (TRM-CH1) Steering neutral adjustments can be made by moving the Steer- Steering Trim ing trim knob to the left or right. Racers Tip When you install a servo, always check to be sure the (L25 - 0 - R25)...
  • Page 14: Steering Dual Rates (D/R-Ch1)

    Steering Dual Rates (D/R-CH1) Use this function to adjust the steering travel of your model. Steering D/R If the model understeers (push) while cornering, add steering by pressing the upper side of the D/R button. When the model oversteers (loose), take away steering by pressing the (30 - 100%)...
  • Page 15: Steering End Point Adjustment (Epa-Ch1)

    Steering End Point Adjustment (EPA-CH1) Use this function to limit the servo Steering EPA movement to the left or right. The servo travel to each side can be in- Range: 0 - 120% dependently adjusted. This feature (Left side) (Right side) will compensate for any difference Adjust the travel of the servo in right or left turning angles or ra-...
  • Page 16: Mc230Cr/Mc330Cr

    MC230CR / MC330CR CANCELLING THE REVERSE FUNCTION The amp reverse function can be cancelled by the following method so that the model can be used even in races that prohibit reverse running. (Brake operation only) MC230CR / MC330CR (Pushbutton switch operation) (Power switch) * When desired, you can enable the cancelled reverse function by repeating the operation shown at the left.
  • Page 17: Flow Chart Of 2Pl-Fm Functions

    Flow Chart of 2PL-FM Functions Power switch turned on Digital trim DT1, DT2, and D/R display The current position is displayed on the LCD screen for about two seconds when each digital trim is operated. Steering Trim Throttle Trim Steering D/R...
  • Page 18 Steering EPA Range: 0 - 120% (Left side) (Right side) Adjust the travel of the servo while operating the steering wheel each way. Throttle EPA Range: 0 - 120% Adjust the travel of the servo (Brake side) (Forward side) while operating the throttle trigger each way.
  • Page 19: Reference

    Reference *Specifications and ratings are subject to change without prior notice. Ratings T2PL-FM S3003 Transmitter Servo (2 channels, FM transmitter) (standard servo) Transmitting frequency: Power requirement: 27, 29, 40, 41, 72 or 75 MHz 6V (common with receiver) Modulation method: FM Current drain: 8mA (at 6V / Idle) Power requirement: Output torque: 4.1kg-cm (57in.-oz.) at 6V...
  • Page 20: Troubleshooting

    If your digital proportional R/C set does not operate, its range is short, it intermit- tently stops operating, or it operates erroneously, take the action shown in the table below. If this does not correct the trouble, please contact a Futaba dealer. Check point...

This manual is also suitable for:

T2pl-fm-75

Table of Contents