FUTABA 4PV Instruction Manual page 35

2.4ghz t-fhss telemetry system
Table of Contents

Advertisement

*When using an S-FHSS(SFH) system (R2104GF, R204GF-E, etc.) receiver, after reach-
ing this point set the transmitter power switch to OFF and go to "Receivers other than T-
FHSS" on page 36.
3
Bring the transmitter and receiver to within 50cm of each other (do not allow the antennae
to touch) and turn on the receiver power.
4
Press the T4PV transmitter's (JOG) button up or down to move the cursor to "LINK: EXE".
When the (JOG) button is pressed for approximately 1 second, "PUSH RX LINK SW" ap-
pears on the screen and a 20 second
countdown begins. Countdown can
be canceled at any time pressing the
(JOG) button up/down or left/right.
5
During the 20 second countdown, push up the receiver side tact switch for approximately 2
seconds. The LED will begin to
blink red. After the receiver LED
switches from blinking red to
green - red - green steady light,
the T4PV generates an electronic
beeping sound, and "LINK:OK"
and "COMPLETE!" appear on
the screen. Reading of the mu-
tual IDs ends and the memorized
receiver ID number appears on
T4PV screen. If an error screen
appears, linking failed. Retry linking. If the transmitter and receiver are linked normally, set
the power switch to the OFF position and then return it to the PWR ON position. If the re-
ceiver LED lights green, linking was successful. Now check servo operation.
*The T4PV and a telemetry type T-FHSS receiver (R304SB, etc.) mutually memorize the
combined ID linked last at each model memory.
Since the T4PV can memorize only 1 receiver ID at each model memory, multiple T-FHSS
receivers cannot be used with the same model memory. When changing the receiver at the
same model memory, re-link the previously linked receiver.
When using multiple telemetry type T-FHSS receivers, link and combine them with each
T4PV model memory.
However, multiple receivers cannot be linked to multiple model memories.
The telemetry function communications status can be checked at the HOME screen.
4PV-Eng-06-Initl_set-P33-38.indd
35
R304SB
(Error screen)
35
2016/08/05
9:00:40

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents