FUTABA 4PV Instruction Manual page 6

A.B.S. Function "TH A.B.S" ........................................................65
Steering Dual Rate/ Throttle ATL "D/R ATL" ..............................69
Select Trim Dial Function "TRIM DIAL" ......................................70
Select Switch Function "SWITCH" .............................................72
Steering Mixing "STR MIX"..........................................................74
Brake Mixing "BRAKE MIX" ........................................................76
Programmable Mixing "PROG MIX" ...........................................78
4WS Mixing "4WS" .......................................................................80
Dual ESC Mixing "DUAL ESC" ....................................................82
Gyro Mixing "GYRO MIX" ............................................................84
CPS Mixing "CPS MIX" ................................................................86
Throttle Mode "TH MODE"..........................................................88
Channel 3/4 "CH3/CH4" ...............................................................92
S.BUS Link Function "SX LINK" .................................................93
ESC Link Function "MC LINK" ....................................................97
Data Transfer "MDL TRANS".....................................................105
Timer Function "TIMER"...........................................................107
6
4PV-Eng-02-Table-P4-7.indd 6
Pulse brake
Steering D/R, Throttle ATL Rate
Selection of functions operated by digital trim and dial
Selection of functions operated by switch
Twin servo steering system
Front and rear independent brake control for 1/5 GP car, etc.
Programmable mixing between arbitrary channels
Special mixing used with Crawler and other 4WS type vehicles
Special mixing used with Crawler and other 4WD type vehicles
Use to set the Futaba car rate gyro
Controls the Futaba CPS-1 channel power switch
Throttle Servo Neutral Position "SXNT" ...................................88
Throttle servo forward and brake operation proportion setting
Idle-Up "IDLUP" .......................................................................89
Idle up at engine start
Neutral Brake "NTBRK"............................................................90
Neutral brake function
Throttle Off (Engine Cut) "THOFF" ..........................................91
Engine cut off by switch
Channel 3/4 Position
Special function, Futaba S.BUS/S.BUS2 servo parameter setup
Special function, Futaba ESC (MC940CR, MC960CR, MC950CR, MC851C, MC602C,
MC402CR, etc.)
The T4PV model memory data to another T4PV
Up, Fuel down, or lap timer
2016/07/29 11:21:16