FUTABA 4PV Instruction Manual page 98

Select the setting item "MODE" by moving the (JOG) button up
or down. Select "READ" by (+) or (-) button, and press the (JOG)
button.
-"COMPLETE!" blinks on the screen and the ESC type and currently set contents are
read.
- If "COM-ERRORR" blinks on the screen, communication with the amp is not being
performed normally. Check the T4PV and ESC connection and the battery connection to
ESC and the ESC power switch and repeat READ.
MC402CR
3
(Writing to ESC)
Execute this function to write the setting data to ESC. See pages
99~104 for the setting data contents.
Select the setting item "MODE" by moving the (JOG) button up
or down. Select "WRITE" by (+) or (-) button, and press the (JOG)
button.
-"COMPLETE!" blinks on the screen and the setting data is written to ESC.
-If "COM-ERROR" blinks on the screen, communication with the amp is not being per-
formed normally. Check the T4PV and ESC connection and the battery connection to ESC
and the ESC power switch and repeat WRITE. In addition, if (NO DATA) is displayed on
the T4PV screen, "WRITE" cannot be selected because there is no setting data to be writ-
ten.
- Different type ESC data cannot be written. If writing is attempted, "COM-ERROR" will
link on the screen to show that the ESC type is wrong.
4
(Initialization)
This function writes the ESC setting data set at the factory to the
connected ESC and T4PV. Perform "READ" before performing
initialization.
Select the setting item "MODE" by moving the (JOG) button up
or down. Select "RESET" by (+) or (-) button, and press the (JOG)
button.
- "COMPLETE!" blinks on the screen and the initial data is written to the ESC. If "COM-
ERROR" blinks, communication with the amp was not performed normally. Check the
T4PV and ESC connection and the battery connection to ESC and the ESC power switch,
and repeat RESET. In addition, when (NO DATA) is displayed on the T4PV screen "RE-
SET" cannot be selected because there is no write initial data.
98
4PV-Eng-08-3-Function-P93-128.indd
MC851C
MC602C
ESC Link Function "MC LINK"
98
MC950CR MC960CR MC940CR
2016/08/05 10:13:19