Removing The Separator - Riso RN SERIES Technical Manual

9.

Removing the Separator

(1) Pull out the print drum, switch off the power, and remove the front cover.
(2) Remove the separator mounting screw (M3 x 8: 1 pc) [A].
(3) Remove the release arm mounting screw (M3 x 8: 1 pc) [B].
(4) Remove the E-ring [C] on the end of the separation shaft, and remove the bearing bush.
A: Separator mounting screw (M3 x 8: 1 pc)
B: Release arm mounting screw (M3 x 8: 1 pc)
C: Separation shaft end E-ring
(5) Push the Separation shaft [E] back slightly, and remove the rear bearing bush from the machine side
frame. Do not push back the shaft more than necessary. To prevent the components mounted on
the rear from detaching, stop pushing back the shaft once the bush in the rear has been removed.
(6) Slide the Separator [F] and Release arm [G] forward and remove both of these parts off the machine.
D
D: Separation shaft rear bearing bush
E: Separation shaft
F: Separator
G: Release arm
A
E
RN (Version 1.0)
CHAPTER 7. PAPER EJECTION SYSTEM
REMOVING THE SEPARATOR
B
F
[Reference]
Photograph of separator assembly and rear mount
(machine drive side)
7 – 15
C
G