Removing The Cutter Unit - Riso RN SERIES Technical Manual

CHAPTER 13. MASTER MAKING SECTION

REMOVING THE CUTTER UNIT

3. Removing the Cutter Unit
(1) Switch off the power, remove the rear cover, and pull out the print drum.
(2) Unplug the rear connector, and remove the Cutter cover [A]. (M4 x 8: 2 pcs)
(3) Remove the Cutter guide plate [C]. (M4 x 8: 2 pcs)
(4) Remove the cutter unit mounting screws. (2 pcs)
(5) Loosen the Tension assembly [D] screw, detach the Belt [F], unplug the cutter unit connector [E], and
then remove the Cutter unit.
A: Cutter cover
B: Load guide (tip)
C: Cutter guide plate
D: Tension assembly
E: Cutter unit connector
F: Belt
E
D
F
13 – 14
RN (Version 1.0)
A
B
C