Jam Errors - Riso RN SERIES Technical Manual

CHAPTER 15. PANEL MESSAGES
DETAILS OF PANEL MESSAGES

Jam errors

Error type A01 [Master feed error]
A01-***
Panel display Master jammed.
Rewind master, and the reset.
Master loading unit switch: OFF -> ON, then master positioning sensor OFF.
Reset method
(Or switch on power again.)
Error point
Master positioning sensor does not go ON even when the master is fed preset amount after
201
write pulse motor is activated.
Master positioning sensor does not go OFF even when the master is rewound during
202
master positioning operation.
211 Master positioning sensor was ON during standby.
214 Master positioning sensor was ON at start of master creation.
215 Faulty gate array control for write pulse motor or load pulse motor.
Error type A02 [Master loading error]
A02-***
Panel display Master jammed.
Rewind master, and the reset.
Master loading unit switch: OFF -> ON, then master positioning sensor OFF.
Reset method
-> Recovery operation
Error point
Master loading sensor was OFF when checking master at specified angle in master loading
509
operation.
Error type A03 [Cutting error]
A03-***
Panel display Master is not correctly wound onto print drum.
Remove master from print drum.
Reset method Print drum set sensor: OFF -> ON -> Recovery operation
Error point
206 Cutting was performed after repeating cutting operation.
Error conditions
Error conditions
Error conditions
15 – 10
RN (Version 1.0)