CHAPTER 8. PRINT DRUM SECTION
REMOVING THE INK SENSOR PCB
10. Removing the Ink Sensor PCB
(1) Pull out the print drum, and remove the following components.
• Screen
• Print drum body
(2) Unplug the connector on the Ink sensor PCB [B].
(3) Remove the mounting screws (M3 x 8: 2 pcs) on the Ink sensor cover [A], and remove the Ink sensor
cover [A] with the Ink sensor PCB [B] inside.
(4) Remove the Ink sensor PCB [B] from the Ink sensor cover [A].
[Work Precautions]
• Take care not to fold or bend the Ink sensor or Overflow sensor.
If they are bent, straighten them out by hand.
[Checking after Reassembly]
• Check that the Ink sensor does not touch the Doctor roller or Driven shaft.
A: Ink sensor cover
B: Ink sensor PCB
A
B
8 – 18
RN (Version 1.0)
A