Removing The Paper Sensor - Riso RN SERIES Technical Manual

3.

Removing the Paper Sensor

(1) Pull out the print drum and remove the following covers.
• Front door
• Front cover
• Rear cover
• Master-removal lower cover
(2) Remove the following components.
• Paper feed tray unit
• Stripper unit
• Paper feed clutch
• Pickup roller shaft ass'y
• Elevator motor
• Guide roller ass'y
• Paper guide plate
(3) Unplug the Paper sensor connector [A] from the Paper guide plate [F].
(4) Remove the Paper sensor (send) [B] mounting screw (M3 x 8: 1 pc) and Paper sensor (receive) [C]
mounting screw (M3 x 8: 1 pc), remove the Paper-sensor covers [D] and [E], and then remove Paper
sensors [B] and [C] from the Paper guide plate [F].
[Precautions on Reassembly]
• Hook the Paper sensors onto the retaining brackets of the Paper guide plate.
A: Connector
B: Paper sensor (send)
C: Paper sensor (receive)
D: Paper-sensor cover (send)
E: Paper-sensor cover (receive)
F: Paper guide plate
CHAPTER 5. SECOND PAPER FEED SECTION
REMOVING THE PAPER SENSOR
A E
5 – 9
RN (Version 1.0)
C
B
F
D