Riso RN SERIES Technical Manual page 216

(5) Remove the master roll, and remove the Master cover [F]. (M4 x 6: 1 pc)
(6) Remove the Master holders [G] on both sides. (M3 x 6: 2 pcs each)
(7) Remove the Master set guide [H]. (M4 x 8: 2 pcs)
F
F: Master cover
G: Master holder
H: Master set guide
(8) Unplug the rear connector, and remove the Stocker cover [I]. (M4 x 8: 2 pcs)
(9) Remove the springs on both sides, and then remove the Master guide [J].
(10) Remove the Load roller guide [K] (M4 x 8: 2 pcs), and then remove the Load roller (bottom).
I: Stocker cover
J: Master guide
K: Load roller guide
CHAPTER 13. MASTER MAKING SECTION
REMOVING THE LOAD ROLLER (BOTTOM)
G
13 – 13
RN (Version 1.0)
H
K
J
I