[Master Making Operation] - Riso RN SERIES Technical Manual

[Master Making Operation]

Start
Master
ON
positioning
OFF
sensor
Master
ON
detection
(1)
OFF
sensor
10
Master end
ON
ms
sensor
OFF
Read/Write
ON
signal
OFF
Write pulse
Feed
motor
OFF
50
ms
Feed
Load pulse
OFF
motor
Return
When ON: Master positioning sensor: Open, Master detection sensor: Open, Master end sensor: Blocked
The master loading and master making operation start once the thermal print head compressing is
complete.
(1) The master detection sensor checks for the presence of a master on starting.
(2) The master end sensor is checked at 10 ms intervals during the master transport operation, and if
the end mark is detected twice in succession, error message [C02-200] is displayed.
(3) The write pulse motor and load pulse motor operate in the feed direction until the master positioning
sensor goes ON. A time-out occurs here when the master is fed A mm, and error message [A01-
201] is displayed. (A = 3 mm + value set in Test mode No. 280)
(4) The write pulse motor operates once the clamp release operation ends for removing the master, and
master creation starts after it has been transported to the position for the start of printing. (C = 6.5
mm + value set in Test mode No. 281)
(5) The load pulse motor operates to transport the leading edge of the master to the master loading
position. (D = 95 mm)
10 10
(2)
ms ms
C mm
(3)
300
ms
D mm
Max A mm
(Error: 201)
(4) Master creation
possible
RN (Version 1.0)
CHAPTER 14. TIMING CHARTS
INDIVIDUAL MASTER MAKING OPERATION
50 50
ms ms
(5)
E[c] mm
(6) Loading possible
14 – 25
F[d] mm
End
(7)