Removing The Elevator Motor - Riso RN SERIES Technical Manual

CHAPTER 4. FIRST PAPER FEED SECTION

REMOVING THE ELEVATOR MOTOR

7. Removing the Elevator Motor
(1) Lower the paper feed tray fully, switch off the power, and pull out the print drum.
(2) Remove the covers.
• Front door
• Front cover
• Master-removal lower cover
(3) Squeeze the wire harness band [E] from the inside, detach from the side frame, and then unplug the
two connectors [F] of the Master removal unit.
(4) Remove the mounting screws (M4 x 6: 4 pcs), and hang free the Drive PCB [A] together with its
mounting bracket.
(5) Remove the Elevator springs [G] from both sides of the Paper feed tray to prevent the tray from
springing up.
(6) Remove the mounting screws (M4 x 8: 2 pcs), unplug the connector [D] of the Elevator motor [B], and
remove the Elevator motor [B].
A
A: Drive PCB
B: Elevator motor
C: Mounting screw
E F
D: Connector of elevator motor
E: Wire harness band
4 – 16
RN (Version 1.0)
G
C
D
F: Connector of master removal unit
G: Elevator spring
B
C