Checking Unit Operations - Riso RN SERIES Technical Manual

4.

Checking Unit Operations

(1) Press the "Start" key to switch ON and start the unit operation. Error checks are performed basically
the same as for normal operation. Some operations stop once the sequence is complete, and
some operations continue until a key is pressed.
(2) A continuous audible tone is given if an error occurs. To cancel errors, press the "Reset" key.
No.
050 Print test A (checker flag pattern)
051 Print test B (mesh pattern)
056 Paper passage test (continuous printing)
057 Low-speed printing
059 Auto power off signal
060 Key check
061 LCD check
062 LED check
063 Unit initialization
150 Shading operation
151 Scanner home position reset
152 Scanner 1 cycle
153 Scanner ADF scanning position movement
154 Scanner lock mode
155 Undo scanner lock mode
156 ADF original feed 1 cycle
157 ADF original feed operation
Creates a master for test pattern 1.
Creates a master for test pattern 2.
Passes paper through.
* "Speed" key can be used.
Prints at 15 rpm.
Switches off power.
Pressing a key displays a specified number on the Print quantity LED.
Displays check pattern on LCD.
LEDs blink alternately
Rests mechanical components to their home positions. (clamps, vertical position,
thermal print head, master compression plate)
Runs shading operation.
Returns scanner to home position.
Performs one scanner operation cycle.
* Adjusts speed according to the variation rate in Test mode No. 192.
Moves scanner to ADF scanning position.
Moves scanner to lock position for transporting.
* Error occurs.
Cancels error status set in Test mode No. 154.
Performs paper passage test for ADF unit alone.
Performs ADF original transport operation.
* Adjusts speed according to the variation rate in Test mode No. 192.
RN (Version 1.0)
CHAPTER 16. TEST MODE
CHECKING UNIT OPERATIONS
Test mode details
16 – 7