Removing The Separator Fan And Paper Receiving Sensor - Riso RN SERIES Technical Manual

CHAPTER 7. PAPER EJECTION SYSTEM

REMOVING THE SEPARATOR FAN AND PAPER RECEIVING SENSOR

8. Removing the Separator Fan and Paper Receiving Sensor
Removing the Separator Fan
(1) Switch off the power, remove the rear cover, and remove the following component.
• Separation fan unit
(2) Remove the nozzle mounting screw (tapping screw M3 x 10: 3 pcs) [A], and remove the Nozzle [E].
(3) Unplug the two separation fan connectors [D].
(4) Remove the mounting screws (M3 x 12: 3 pcs each) [B] from the two Separation fans [C], and
remove both Separation fans [C].
B
C
D
A: Nozzle mounting screw (tapping screws M3 x 10: 3 pcs)
B: Separation fan mounting screws (M3 x 12: 3 pcs each)
C: Separation fan
D: Separation fan connectors
E: Nozzle
Removing the Paper Receiving Sensor
(5) Disengage the Paper receiving sensor [F] from the hook [G] and remove the Paper receiving
sensor [F].
(6) Unplug the Paper receiving sensor connector [H].
F: Paper ejection sensor
G: Hook
H: Connector
A
B
F
RN (Version 1.0)
A E
B B
G H
7 – 14
A
B
C
D