Removing The Adf Original Registration Sensor - Riso RN SERIES Technical Manual

CHAPTER 12. ADF SCANNING SECTION

REMOVING THE ADF ORIGINAL REGISTRATION SENSOR

5. Removing the ADF Original Registration Sensor
(1) Switch off the power and open the ADF unit. Now remove the two screws (M3 x 10), and remove the
ADF cover. Finally, close the ADF unit.
(2) Remove the connector, lift up the actuator and move it to the left end, and release the clips on the
ADF original registration sensor [A] to remove it.
A: ADF original registration sensor
12 – 16
RN (Version 1.0)
A