Riso RN SERIES Technical Manual page 258

CHAPTER 15. PANEL MESSAGES
DETAILS OF PANEL MESSAGES
Error type T17 [Solenoid counter not connected]
T17-***
A problem has occurred.
Panel display
Press the lower right "Jam Reset" key.
If resetting is not possible, notify technician of T17-***.
Reset method Solenoid counter connection signal ON
Error point
020 Solenoid counter is not connected.
Error type T19 [Thermal pressure motor lock]
T19-***
A problem has occurred.
Panel display
Press the lower right "Jam Reset" key.
If resetting is not possible, notify technician of T19-***.
Reset method Jam reset
Error point
TPH pressure sensor does not go OFF within 250 ms after the thermal pressure motor
207
activates.
208 TPH pressure sensor does not go OFF within 1 s after the thermal pressure motor activates.
Error type T20 [Master creation motor lock]
T20-***
A problem has occurred.
Panel display
Press the lower right "Jam Reset" key.
If resetting is not possible, notify technician of T20-***.
Reset method Jam reset
Error point
416 An overload current was detected in the feed motor.
Error type T23 [Scanner lock not released]
T23-***
Panel display Scanner is locked.
Release lock.
Reset method Clear the scanner lock mode. (Test mode No. 155)
Error point
111 In scanner lock mode.
Error conditions
Error conditions
Error conditions
Error conditions
15 – 8
RN (Version 1.0)