Riso RN SERIES Technical Manual page 124

(9) Pull the print drum support (R) [K] from the ink distributor.
(10) Pull the Ink outlet nozzle [A] from the ink distributor.
(11) Remove the mounting screws (M4 x 8: 3 pcs) [B] on the Drum front support ass'y [C], and remove the
Drum front support ass'y [C] from the drum shaft clamper.
A
(12) Loosen the 3-mm Allen bolt [E] on the Drum shaft clamper [D], and slide out the Drum shaft clamper
[D] from the ink distributor.
(13) Slide out the Print drum support (F) [G] from the ink distributor, and pull the junction wire harness [F]
out through the Print drum support (F) [G].
[Continued on next page]
D
E
CHAPTER 8. PRINT DRUM SECTION
REMOVING THE PRINT DRUM SUPPORTS (R) AND (F)
F
8 – 23
RN (Version 1.0)
C
A: Ink outlet nozzle
B: Mounting screws (M4 x 8: 3 pcs)
C: Drum front support ass'y
B
G
D: Drum shaft clamper
E: 3-mm Allen bolt
F: Junction wire harness
G: Print drum support (F)