Riso RN SERIES Technical Manual page 121

CHAPTER 8. PRINT DRUM SECTION
REMOVING THE SQUEEGEE ROLLER
(5) With the print drum at position-A, remove the mounting screws (M4 x 8: 2 pcs each) on the Squeegee
frames [L] via the holes in the left and right Print drum supports.
(6) Remove the mounting screw (M4 x 6: 1 pc), and remove the Print drum lock plate ass'y [E].
(7) Remove the Pivot screw [F] on the front of the print drum via the opening in the Print drum support (F)
where the Print drum lock plate ass'y was removed. Likewise, remove the Pivot screw [G] on the
front of the print drum via the opening in the Print drum support (R).
(8) Remove the Squeegee bottom ass'y [H] from the squeegee unit.
F: Pivot screw (print drum front)
G: Pivot screw (print drum rear)
H: Squeegee bottom ass'y
L
L: Squeegee frames
F
8 – 20
RN (Version 1.0)
E
E: Print drum lock plate ass'y
G
H
[Continued on next page]